A long time ago, I found an archive of PDFs of papercraft buildings designed for WHFRP gaming. I don't remember now where they came from, and it's taken me years to get around to actually putting any of them together. They're very simple models, and they don't take much time to assemble, which is a good thing, and they're quite attractive when they're glued together.
They're in "Fantasy-Tudor" style, which perhaps isn't especially suitable for WWII gaming, but I like the look of them and they'd definitely be an improvement on wooden blocks.
I'm experimenting at the moment with scaling — they're intended for use with 25-28mm figures, and all my wargaming is either 6mm or 15mm. This one I printed at 50%, and it's just a fraction too small for 15mm; it's about 60mm tall to the peak of the roof — I'll bump up the next one to 60% and see how that looks.
This is an instance where a laser printer isn't as useful as an inkjet would be, for two reasons:
- The laser won't print on anything heavier than about 100gsm paper
- The fused toner is somewhat water-resistant, which makes gluing with PVA problematic.
The first issue I can get around by laminating prints to light card with spray glue, but the second is trickier. I can scrape away the toner on the glue-tabs, but that's kind of a pain. I think I may just re-composite a whole bunch of them on to A3 layouts and get them printed commercially on light card; it's not too expensive, and it would save a lot of faffing about.
One thing that's an issue with any papercraft model is that corners and edges tend to stand out like dog's bollocks, bright white against the printed textures where the paper has been cut or folded. It pays to run around these areas with a felt pen to subdue the glare — black is OK, but sepia or grey is less cartoonish.